Front Mask

Genuine Mazda Accessory
Sold by Mazda Parts Department

Price: $150.00

OUCH!

Yup, 150 smackers.  Yes, I know, I could get a LeBra cheaper.  But I wanted a GENUINE MAZDA part, OK?  (not good enough reason, I know, but its the best I got... :)

The first thing I will tell you is to PLEASE get the right tools for the job.  This is not a snap on mask.  This will require you to replace two screws at each side (in the corner of the wheel wells) with special screws that have a special head where the mask snaps on too.  A pain in the butt, but it makes installation and fit a lot easier.

I didn't have the Exacto knife handy when I installed the mask, so I couldn't cut out the holes for the fog lights.  Oh well, I'll get around to it sooner or later...

The mask fits like it was designed for the Miata.. hey, wait a minute, IT WAS designed for the Miata.  At $150 its not the best value out there, but if you are like me and appreciate the symmetry of stock parts, then this is the mask for you.  The cool Miata logo ALMOST makes it worth it.  Almost. :)

Mod Summary:

• Total mod time: 1  hour 30 minutes (without the right tools ... 30 minutes with the right tools :)
• Mod difficulty (1-10, 10 being hardest): 20 (without the right tools, a 2 or 3 if you have the right tools :)
• Mod cost: $150.00 YIKES!
• Mod impact: Protects the front end of your Miata from flying bugs.
• Recommended: Not really.  Only if you want to protect your car, look cool and have $150 burning a hole in your pocket all at once...

[ Accessories Home ]